subject
Engineering, 23.09.2020 14:01 Geo777

We jump ahead to modern times and find Lazydog having lunch at Shoney's. While pounding down a BBQ bacon cheeseburger (only 1470 calories and 49 fat grams), the good professor worked on the following problems. Grab yourself an 875 calorie Ultimate Hot Fudge Cake from Shoney's and help the prestigious professor solve these problems. 1. The honored Lazydog fondly recalls the many times he has sliced a golf ball into the water. This leads him to decide to calculate the terminal velocity in water of a 4.3 cm diameter ball that has a specific gravity of 1.22. Assume the viscosity of water is 1.0x10-3 Paâ‹…s. What do you calculate as the terminal velocity of this ball in water?(include units with answer)2. The distinguished Lazydog now decides to calculate how long it would take to drain a 2.8 ft wide by 5.2 ft long bathtub from full to half full. The initial height of the water in the tub is 2.2 ft and the water goes out a 2.3 inch diameter drain in the bottom of the tub.(include units with answer)3. The celebrated Lazydog has recently added a 87 m3 workshop on to his house. What diameter must a 16 m long air duct have if the heating and air conditioning system is to replenish the air in the room every 16 minutes? The pump can exert a change in gage pressure of0.63x10-3 atm. The viscosity of air is 0.018x10-3 Paâ‹…s.(include units with answer)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
question
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
question
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
You know the right answer?
We jump ahead to modern times and find Lazydog having lunch at Shoney's. While pounding down a BBQ b...
Questions