subject
Engineering, 21.09.2020 23:01 alphaaz23415

Strawberries contain about 15 wt% solids and 85 wt% water. To make strawberry jam, crushed strawberries and sugar are mixed in a 45:55 mass ratio, and the mixture is heated to evaporate water until the residue contains one-third water by mass. a) Draw and label a flowchart of this process.
b) Do the degree-of-freedom analysis and show that the system has zero degrees of freedom (i. e., the number of unknown process variables equals the number of equations relating them). If you have too many unknowns, think about what you might have forgotten to do.
c) Calculate how many pounds of strawberries are needed to make a pound of jam.
d) Making a pound of jam is something you could accomplish in your own kitchen (or maybe even a dorm room). However, a typical manufacturing line for jam might produce 1500lbm/h1500lb m/h. List technical and economic factors you would have to take into account as you scaled up this process from your kitchen to a commercial operation.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
question
Engineering, 06.07.2019 03:20
Major ingredients of traditional ceramics (a) silica (b) clay (c) feldspar (d) all
Answers: 1
You know the right answer?
Strawberries contain about 15 wt% solids and 85 wt% water. To make strawberry jam, crushed strawberr...
Questions
question
Chemistry, 26.07.2019 16:00
question
Mathematics, 26.07.2019 16:00