Engineering, 20.09.2020 19:01 honeylebling

You are evaluating a Voice over IP (VoIP) phone. The phone samples human speech at 8,000 Hz using a 8-bit sample size to produce a voice bit stream (64
kbps). The phone must then packetize the voice stream for delivery to a peer
VoIP device. The phone will generate a packet for every 20ms of voice. Real-time
Transport Protocol (RTP, IETF RFC 3550) will be used to encapsulate the voice
data, which will then be encapsulated in UDP, then IPv4 (no options), and finally
Ethernet (18 bytes of overhead).
a) Draw a picture of this VoIP packet including all encapsulation layers, and label
sizes.
b) What is the ratio of overhead for a single VoIP packet?
c) What is the physical layer bitrate (kbps) for the VoIP flow?
d) What is the packet rate? (packets/second)

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

Answer

You know the right answer?

You are evaluating a Voice over IP (VoIP) phone. The phone samples human speech at 8,000 Hz using a...

Questions