subject
Engineering, 20.09.2020 17:01 ekids22

Two liters of a liquid chemical is spilled on the laboratory floor. Assume 1 atm of pressure and a temperature of 25°C. a. If the center of the liquid pool is 2 mm deep, calculate the area of the pool. b. What ventilation rate, in m3/s, is required to prevent the air concentration from exceeding the TLV for the chemical of 100 ppm? c. Ventilation air is provided for the lab via a 0.5-m2 duct. The air velocity exiting the duct is measured with a velometer at 30 m/s. Calculate the volumetric flow of air from this duct in m3/s. Is this adequate ventilation for this spill?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
question
Engineering, 04.07.2019 19:10
Agas is compressed from vi 0.3 m, p 1 bar to of v2 0.1 m3, p2--3 bar. pressure and volume are related linearly during the process. for the gas, find the work, in kj.
Answers: 2
question
Engineering, 04.07.2019 19:10
Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj
Answers: 2
You know the right answer?
Two liters of a liquid chemical is spilled on the laboratory floor. Assume 1 atm of pressure and a t...
Questions
question
Mathematics, 13.01.2020 01:31
question
Social Studies, 13.01.2020 01:31