Engineering, 03.09.2020 14:01 chrisholmes176
What will be the cost of 5m long and 1.5m high masonry check dam having top width 25cm and bottom width 1.25m having spillway of 3m×2m×0.5m. Assume local rate for estimation of cost.
Answers: 3
Engineering, 04.07.2019 19:10
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
Engineering, 06.07.2019 02:30
A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush
Answers: 3
Engineering, 06.07.2019 02:30
A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.
Answers: 1
What will be the cost of 5m long and 1.5m high masonry check dam having top width 25cm and bottom wi...
Mathematics, 15.07.2019 00:00
Social Studies, 15.07.2019 00:00
History, 15.07.2019 00:00
Physics, 15.07.2019 00:00
Health, 15.07.2019 00:00
Mathematics, 15.07.2019 00:00
Mathematics, 15.07.2019 00:00
History, 15.07.2019 00:00
Health, 15.07.2019 00:00