Engineering, 01.09.2020 23:01 getsic
Consider a rod transmitting a tensile force. The following materials are being considered for the given application: tungsten carbide, zinc alloy, polycarbonate polymer, and aluminum alloy. 3. a. Determine the material index fM). b. Using Ashby chart (Fig. 2.19), select the best material for its strength to weight ratio.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
You know the right answer?
Consider a rod transmitting a tensile force. The following materials are being considered for the gi...
Questions
History, 27.06.2019 07:30
History, 27.06.2019 07:30
History, 27.06.2019 07:30
Social Studies, 27.06.2019 07:30
History, 27.06.2019 07:30
Mathematics, 27.06.2019 07:30
Mathematics, 27.06.2019 07:30
Mathematics, 27.06.2019 07:30
English, 27.06.2019 07:30
Mathematics, 27.06.2019 07:30
English, 27.06.2019 07:30
Health, 27.06.2019 07:30
English, 27.06.2019 07:30
English, 27.06.2019 07:30
Mathematics, 27.06.2019 07:30
