You see a group of small fuse holders on a d i n rail in an industrial control cabinet the fuse holders are in groups of 5 and are separated by a single terminal block what's connected to the terminal block A. the AC or DC power to the fuses
B. system ground
C. the power supply natural
D. a control signal

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.