Engineering, 27.08.2020 04:01 sierraseideman1023

Help me please. I need to solve it in half an hour Ex: It is required to design a spur gear speed reducer for a compressor running at 250rpm driven by 7.5 kW, 1000rpm electric motor. The center distance between the axes of the gear shafts should be exactly 250mm. The starting torque of the motor can be assumed to be 150% of the rated torque. The gears are made of carbon steel (SAE2345).The pressure angle
is 20°. The factor of safety is 2 for preliminary design .Assume that the number of teeth for pinion between 20 to 30 teeth and the face width is ten times the module.
1. Design the gears and specify their dimensions.
2. What is the bending strength in this case?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 19:10

How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

Engineering, 04.07.2019 19:20

To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.

Answers: 1

Answer

You know the right answer?

Help me please. I need to solve it in half an hour Ex: It is required to design a spur gear speed r...

Questions