Engineering, 19.08.2020 18:01 brownvester44
A refrigeration plant operates in Pretoria on refrigerant R134a at an evaporator pressure of 105kPa (gauge) and a condensing pressure of 920 kPa (gauge). There is a sub-cooling of 3K with a superheat of the gas entering the compressor of 8K. The compressor is a four-cylinder reciprocating compressor with a bore of 67mm and a stroke of 57mm with an estimated capacity of 35kW. The compressor is directly coupled to an electric motor running at 1470rev/min and a power consumption of 19,5 kW. Calculate: 1. The clearance volume efficiency if the compressor clearance is 3,6% 2. The actual volumetric efficiency 3. The compression efficiency when the mechanical efficiency is 85% and the motor efficiency 90%.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
Engineering, 04.07.2019 18:20
Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
You know the right answer?
A refrigeration plant operates in Pretoria on refrigerant R134a at an evaporator pressure of 105kPa...
Questions
History, 20.04.2021 18:50
Social Studies, 20.04.2021 18:50
Mathematics, 20.04.2021 18:50
Mathematics, 20.04.2021 18:50
Mathematics, 20.04.2021 18:50
Mathematics, 20.04.2021 18:50
