Engineering, 12.08.2020 04:01 palmsalt05

chain sprocket system is designed to drive a shaft. Assume the following conditions: i. Use SAE 1018 steel for the key (which is the weakest material in comparison to other components) ii. The chain sprocket has a bore diameter of 2.5" and the hub length of 3.125" ill. The sprocket delivers 110 horsepower to a shaft with the rotation of 1700 rpm. iv. Safety factor of 3 Determine 1). The dimensions of the square key: Width: Minimum length (so the key will not fail): 2). The minimum contact length on the hub (so the hub will not fail);

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:20

Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?

Answers: 1

Answer

Engineering, 06.07.2019 02:30

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

Answer

Engineering, 06.07.2019 03:10

Consider two concentric spheres forming an enclosure with diameters of 12 cm and 18 cm the spheres are maintained at uniform temperatures ti-50°c and t2 = 250°c and have emissivities .45 and .8, respectively. determine the net rate of radiation heat transfer between the two spheres per unit surface area.

Answers: 1

Answer

Engineering, 06.07.2019 04:10

Apinion having 30 involute teeth of 6,5 module rotates at 220 r/min and transmits 2 kw to a gear wheel having 70 teeth; the addendum on both wheels is 4 of the circular pitch and the angle of obliquity is 200. determine; 3.1 the lengths of the path of approach and the arc of approach 3.2 the normal force between the teeth at an instant when there is only one pair of teeth in contact

Answers: 2

Answer

You know the right answer?

chain sprocket system is designed to drive a shaft. Assume the following conditions: i. Use SAE 1018...

Questions