Engineering, 04.08.2020 14:01 ashylynn2423
. A GTAW operation is performed on low carbon steel, whose unit melting energy is 10.3 J/mm3 . The welding voltage is 22 volts and the current is 135 amps. The heat transfer factor is 0.7 (convection heat loss of 30%) and the melting factor is 0.65 (conduction heat loss of 35%). If filler metal wire of 3.5 mm diameter is added to the operation, the final weld bead is composed of 60% volume of filler and 40% volume base metal. If the travel speed in the operation is 5 mm/sec, determine:
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
You know the right answer?
. A GTAW operation is performed on low carbon steel, whose unit melting energy is 10.3 J/mm3 . The w...
Questions
Mathematics, 01.02.2020 20:44
Mathematics, 01.02.2020 20:44
English, 01.02.2020 20:44
Computers and Technology, 01.02.2020 20:44
Biology, 01.02.2020 20:44
Computers and Technology, 01.02.2020 20:44
Mathematics, 01.02.2020 20:44
Mathematics, 01.02.2020 20:44
Biology, 01.02.2020 20:44
