subject
Engineering, 27.07.2020 20:01 lolll52

A 50 cm diameter pumping well and site detailed on the next page. The hydraulic conductivity of unconfined aquifer is estimated to be about (1.2 m/day). The bottom of the aquifer

is approximately horizontal at a depth of (100 m) below the ground surface. Under natural

conditions, the water table is nearly horizontal at a depth of (3 m) below the ground surface. What is the minimum discharge that can be used that no effect on-site if you know the water table of

pumping well below the ground level was equal to 8 m? Then, what is the drawdown at point A?

Assuming steady-state conditions.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?
Answers: 1
question
Engineering, 06.07.2019 02:30
In a unit cell of fcc structure, indicate the position of one of the tetrahedral interstitial sites by plotting the corresponding tetrahedron. do the same for one of the octahedral interstitial sites (in a separate fcc unit cell). mark the positions of all the tetrahedral and octahedral interstitial sites in the unit cells. how many equivalent tetrahedral sites and how many equivalent octahedral sites are contained in a fcc unit cell, respectively. what is the coordination number for a tetrahedral site and what is the coordination number for an octahedral site?
Answers: 2
question
Engineering, 06.07.2019 05:10
The crank case of an automobile is 80 cm long 30 cm wide and 10 cm deep. find out the rate of heat flow from the crank case to the atmosphere when the automobile is moving at 90 km/hr. assume that the vibration of the engine and the chassis iaduce the transition from laminar to turbulent boundary layer may be considered over the entire surface. also find out the drag force on the total surface of the crank case. take the same average convective heat transfer coefficient and average shear stress for front and rare surfaces as for the bottom rnd sides crank case surface temperature is 75°c and atmospheric air temperature is 5 c
Answers: 2
question
Engineering, 06.07.2019 05:20
Two kg of refrigerant 134a contained in a piston-cylinder assembly is initially at 4 bar and 70°c. the refrigerant undergoes a constant pressure process to a final state of a saturated vapor. kinetic and potential energy effects can be neglected. a) show the process on a pv diagram b) determine the work for the process, in kj c) determine the heat transfer during the process, in kj
Answers: 3
You know the right answer?
A 50 cm diameter pumping well and site detailed on the next page. The hydraulic conductivity of unc...
Questions
question
English, 12.10.2020 14:01
question
Mathematics, 12.10.2020 14:01