subject
Engineering, 22.07.2020 21:01 perezesmeralda78

A drilling operation is to be performed with a 12.7 mm diameter drill on cast iron. The hole depth is 60 mm and the drill point angle is 118โˆ˜. The cutting speed is 25 m/min and the feed is 0.30 mm/rev. Calculate:. a) The cutting time (min) to complete the drilling operation
b) Material removal rate (mm3/min) during the operation, after the drill bit reaches full diameter.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26ยฐc with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70ยฐc. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
A drilling operation is to be performed with a 12.7 mm diameter drill on cast iron. The hole depth i...
Questions
question
Mathematics, 13.09.2020 08:01
question
Chemistry, 13.09.2020 08:01
question
English, 13.09.2020 08:01
question
Biology, 13.09.2020 08:01
question
Mathematics, 13.09.2020 08:01
question
Mathematics, 13.09.2020 08:01
question
Mathematics, 13.09.2020 08:01
question
Mathematics, 13.09.2020 08:01
question
Mathematics, 13.09.2020 08:01
question
Biology, 13.09.2020 08:01
question
Mathematics, 13.09.2020 08:01
question
Geography, 13.09.2020 08:01
question
Mathematics, 13.09.2020 08:01
question
Mathematics, 13.09.2020 08:01
question
Mathematics, 13.09.2020 08:01
question
Mathematics, 13.09.2020 08:01
question
Mathematics, 13.09.2020 08:01
question
English, 13.09.2020 08:01
question
English, 13.09.2020 08:01
question
Mathematics, 13.09.2020 08:01