Design ROM that has 16 locations each 32 bits wide. The 16 locations have the values like 0xDEADBEEF, 0xCAFEBABE, 0xDEADFEED and so on of your choice. There will be a chipselect (CS) input that activates the chip. The address input to the chip is a vector. The output would also be a vector that should send out the data already initialized at the active clock edge, depending on the address input to the chip.

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Steam enters a turbine at steady state at 2 mpa, 360°c with a velocity of 100 m/s. saturated vapor exits at 0.1 mpa and a velocity of 50 m/s. the elevation of the inlet is 3 m higher than at the exit. the mass flow rate of the steam is 15 kg/s, and the power developed is 7 mw. let g 9.81 m/s^2. determine: a)-the area at the inlet, in m^2 b)-the rate of heat transfer between the turbine and surroundings, in kw c)-draw a p-v diagram for this process.