Engineering, 05.07.2020 14:01 salazarx062

Suppose there a joint where the bolts have a stiffness of 0.877 MN/mm per bolt and the members have a stiffness of 3.116 MN/mm per bolt. The bolts are M14 x 2, ISO 12.9 class, installed for permanent installation. The maximum load is 45,000 N per bolt. For the fatigue calculation, consider that the minimum load is 7,500 N per bolt. a) What is the stiffness constant, C, of the joint? b) What is the proof load, SpAt, of the bolt, in N? c) What is the pre-load, Fi, on the bolt, in N? d) What is the factor of safety in yield, np? e) What is the load factor of safety, nu? f) What is the joint separation factor of safety, no? g) What is the midrange stress, Om, in MPa? h) What is the amplitude stress, da, in MPa? i) What is the initial stress, oi, in MPa? j) What is the fatigue factor of safety, né? k) Is this joint safe in both static and fatigue loading?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

You know the right answer?

Suppose there a joint where the bolts have a stiffness of 0.877 MN/mm per bolt and the members have...

Questions