Engineering, 04.07.2020 14:01 ashley4329
(a) Design a low-pass filter with a cutoff frequency of 12 kHz. Use0.15 uF capacitor and an appropriate resistor. B) Sketch and label the circuit. C) What is the gain of the filter at a frequencyof 20 kHz? Give your answer both as ratio (Vout/Vin) and in dB
Answers: 3
 making R the subject of the formula in other to get the resistance of the low pass filter resistor
= 88.42 OHMS
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
You know the right answer?
(a) Design a low-pass filter with a cutoff frequency of 12 kHz. Use0.15 uF capacitor and an appropri...
Questions
Mathematics, 01.09.2020 23:01
Mathematics, 01.09.2020 23:01
Mathematics, 01.09.2020 23:01
Advanced Placement (AP), 01.09.2020 23:01
Mathematics, 01.09.2020 23:01
English, 01.09.2020 23:01
Computers and Technology, 01.09.2020 23:01
