Engineering, 05.07.2020 01:01 604341

A Small-sized Wind Turbine is schematically shown in Fig (a), and is delivering a maximum rated power of ( 50 KW ). This Wind Turbine is using " A Single-Stage- Spur- gearbox " to speed up the main Drive shaft speed from 20 rpm to 1400 rpm ( see Fig (b) ). In order to absorb shock loads , such gear box is suspended in space by two torque arms -as shown in Fig ( c ); which is attached to the turbine housing by a Bolted Joint, of 6 equally spaced Hexagonal bolts. requirements:

1- The Standard Design Procedure

2-Design of Torque arm,

3-Design of the Bolted Joint

4-Design of the used Spur gear Pair

5-Design of main Input Shaft together with its KEY

6-Select the Right Deep Groove Ball bearings; which are supporting the main input Shaft, and Finally

7-The Configuration of the Main Input Shaft (Product Concept, DFM, DFA, Dimensions, Fits, and Tolerances for mating parts)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

Answer

You know the right answer?

A Small-sized Wind Turbine is schematically shown in Fig (a), and is delivering a maximum rated powe...

Questions