Engineering, 05.07.2020 14:01 blakestuhan

For 120 consecutive days, a process engineer has measured the weight and examined the surface for imperfections of a component after it has been coated with a special paint. Each day, she takes a sample of 45 components. Across all sampled parts, the average weight is 112 grams, the standard deviation of weight is 0.16 gram, and there are in total 103 parts with surface imperfections. Round your answer to 4 digits after the decimal point if it is not an integer. Do NOT use comma in your numeric answers. Sample size is .Number of samples is .When constructing a x-bar chart:The center line should be .ESD(x-bar) equals .The upper control limit (UCL) should be .The lower control limit (LCL) should be .When constructing a p chart:The center line should be .ESD(p) equals .The upper control limit (UCL) should be .The lower control limit (LCL) should be

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 19:10

An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling

Answers: 2

Answer

Engineering, 04.07.2019 19:20

The process in which the system pressure remain constant is called a)-isobaric b)-isochoric c)-isolated d)-isothermal

Answers: 3

Answer

You know the right answer?

For 120 consecutive days, a process engineer has measured the weight and examined the surface for im...

Questions