Engineering, 27.06.2020 02:01 DaFuzzyDude

The center-to-center distance from reference hole A to hole B is 3.00"+/-0.11". Hole A will be ø(4.0"+/-0.1"). If a jig is to be used to locate hole B by inserting a locator pin in hole A of ø(3.85"+/-0.05"), due to the slack between the jig locator pin and hole A: a. What are the potential limits in the location of hole B? b. Are these potential limits acceptable? c. If the potential limits are not acceptable, how would you make them acceptable? In part c, a bushing will be used to make hole B. What should be the specification for bushing location tolerance?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

You know the right answer?

The center-to-center distance from reference hole A to hole B is 3.00"+/-0.11". Hole A will be ø(4.0...

Questions