subject
Engineering, 26.06.2020 16:01 jessecabrown1

1. An automobile travels along a straight road at 15.65 m/s through a 11.18 m/s speed zone. A police car observed the automobile. At the instant that the two
vehicles are abreast of each other, the police car starts to pursue the automobile at
a constant acceleration of 1.96 m/s². The motorist noticed the police car in his rear
view mirror 12 s after the police car started the pursuit and applied his brakes and
decelerates at 3.05 m/s². (Hint: The police will not go against the law.)
a) Find the total time required for the police car to overtake the automobile.
(12 marks)
b) Find the total distance travelled by the police car while overtaking the
automobile.
(2 marks)
c) Find the speed of the police car at the time it overtakes the automobile.
(2 marks)
d) Find the speed of the automobile at the time it was overtaken by the police car.
(2 marks)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
question
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
You know the right answer?
1. An automobile travels along a straight road at 15.65 m/s through a 11.18 m/s speed zone. A polic...
Questions
question
Mathematics, 31.03.2020 22:33