Engineering, 06.06.2020 15:57 josephdakota
Generally, final design results are rounded to or fixed to three digits because the given data cannot justify a greater display. In addition, prefixes should be selected so as to limit number strings to no more than four digits to the left of the decimal point. Using these rules, as well as those for the choice of prefixes, solve the following relations: Captionless Image
Answers: 3
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 06.07.2019 03:20
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
Engineering, 06.07.2019 03:30
State the stress optic law in two dimension and obtain an expression for the same.
Answers: 2
Engineering, 06.07.2019 05:20
Acantilever of 3 m length with a t-shaped cross-section is loaded by three concentrated loads: w,-80 n at the free end, w 30 n, and w,-60 n at a distance of 1 m from the free end. all loads are applied at the outer edges of the flange as indicated in the sketch below. (a)-determine the maximum torsional shear stresses in the flange and in the web at distances 0.5 m and 2.5 m from the free end (sections i and ii marked in the sketch) b)- determine thefh end cross section assuming a shear modulus of 210 gpa.
Answers: 3
Generally, final design results are rounded to or fixed to three digits because the given data canno...
Physics, 03.06.2021 09:30
Advanced Placement (AP), 03.06.2021 09:30
Mathematics, 03.06.2021 09:30
Mathematics, 03.06.2021 09:30
Mathematics, 03.06.2021 09:30
Mathematics, 03.06.2021 09:30
Mathematics, 03.06.2021 09:30
Mathematics, 03.06.2021 09:30