subject
Engineering, 05.06.2020 05:02 kj44

Choose the most appropriate answer in each of the following cases (with a brief justification). A: Given a channel capacity C shared by N stations that generate data at maximum rates, the CDMA-based transmission of data using M-chip code sequences allows each station to enjoy an effective transmission bandwidth share B, where: (i) B β‰ˆ C N (ii) B β‰ˆ C M (iii) B β†’ C(βˆ’) (iv) B β‰ˆ C N+M

B: IEEE 802.3 Ethernet (CSMA/CD) specifies a minimum data packet size, because: (i) Applications always generate large sized data packets (ii) Channel efficiency increases by amortizing the header overhead across a certain minimum packet size (iii) The sender of a packet should transmit long enough to hear any collisions that may occur at the farthest end of bus (iv) The application programming becomes simpler by sending a less number of large-sized packets

C: In comparison to transmission over a wired network, the signal strength over a wireless network decays rapidly with respect to the distance of receiver, because: (i) Signal energy propagates faster over wireless medium than over wired medium (ii) Signal energy propagates in all directions over wireless medium, whereas energy propagates only in the direction of wired medium; (iii) Noise signals are stronger in wireless medium that in wired medium (iv) Signal is sent on a high frequency carrier over wireless medium, whereas signal is sent as baseband over wired medium.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24Β°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
question
Engineering, 04.07.2019 18:10
Fluids at rest possess no flow energy. a)- true b)- false
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20Β°c. the pipe has an outer surface temperature of 65Β°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
You know the right answer?
Choose the most appropriate answer in each of the following cases (with a brief justification). A:...
Questions
question
Mathematics, 04.08.2019 05:30
question
Biology, 04.08.2019 05:30