Engineering, 21.05.2020 22:59 Yommms
A continuous and aligned fiber-reinforced composite having a cross-sectional area of 1130 mm2is subjected to an external tensile load. If the stresses sustained by the fiber and matrix phases are 156 MPa and 2.75 MPa, respectively, the force sustained by the fiber phase is 74,000 Nand the total longitudinal strain is1.25x 10-3, determine (a)the force sustained by the matrix phase, (b)the modulus of elasticity of the composite material in the longitudinal direction, and (c)the moduli of elasticity for the fiber and matrix phases.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 19:10
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
You know the right answer?
A continuous and aligned fiber-reinforced composite having a cross-sectional area of 1130 mm2is subj...
Questions
History, 15.07.2019 08:00
Mathematics, 15.07.2019 08:00
English, 15.07.2019 08:00
Physics, 15.07.2019 08:00
Mathematics, 15.07.2019 08:00
Mathematics, 15.07.2019 08:00
