Will give brainliest and 100 points when done
You are to design and build a machine that will...
Engineering, 21.05.2020 03:00 whitethunder05
Will give brainliest and 100 points when done
You are to design and build a machine that will pop a balloon in a minimum of 8 steps using the design restrictions outlined on this assignment.
1. Have the simple machine names displayed clearly on the machine (label your station such as wheel and axle if you use a car, truck, etc.
2. Use all 6 simple machines: Lever, Pulley, Inclined Plane, Wheel and Axle, Wedge, Screw (See the explanation below titled Basic Physics of simple machines).
3. Perform a minimum of 8 steps from start to finish.
4. Creatively decorated at least 4 steps
5. The only time a human may touch your device is to begin the apparatus.
6. Must complete the task within 5 minutes.
7. Must not contain any offensive materials or themes.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
Engineering, 04.07.2019 19:10
With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.
Answers: 1
Engineering, 06.07.2019 03:20
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
Engineering, 06.07.2019 03:30
Abrayton cycle operates with a regenerator on the air-standard with properties evaluated at 400 k. the tem- perature of the air entering the compressor is 350k while the temperature of the air exiting the compressor is 600 k. the temperature of the air entering the turbine is 1600 k. the overall cycle produced 600 kj/kg of net work out. assuming a regenerator effectiveness of 0.8, what is the temperature of the air before heat addition (combustion)? draw this process on a t - s diagram
Answers: 3
You know the right answer?
Questions
Mathematics, 31.05.2021 15:10
History, 31.05.2021 15:10
Mathematics, 31.05.2021 15:10
Business, 31.05.2021 15:10
