subject
Engineering, 07.05.2020 05:14 jholland03

A speed reducer has 20 deg full depth teeth and consisct of a 20 tooth steel spur pinion driving a 50 tooth cast iron gear. the horse power transmitted is 12 at a pinion speed of 1200 rev/min. for a dimateral pitch of 8 teeth/ in and a face width of 1.5 in find the contact stress. the yuong's modulus of the steel is 30E6 and young's modulus of cast iron is 15E6. use a poisson's ratio of 0.3 for both materials. use equation 14-14 to calc the contact stress in the gear only.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
question
Engineering, 04.07.2019 18:10
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
question
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
You know the right answer?
A speed reducer has 20 deg full depth teeth and consisct of a 20 tooth steel spur pinion driving a 5...
Questions
question
Social Studies, 17.01.2021 04:50
question
Health, 17.01.2021 04:50
question
Mathematics, 17.01.2021 04:50
question
Mathematics, 17.01.2021 04:50
question
Health, 17.01.2021 04:50