subject
Engineering, 05.05.2020 22:32 gonzalesalexiaouv1bg

Please solve the following problems using the hardness data from the Jominy end-quench test for 8660 steel and the data for cooling rates at different locations in round bars during several quenches related to positions along a Jominy bar. 1. For a 8660 steel bar with a 2-inch diameter quenched by mildly agitated oil, please estimate the Rockwell hardness for both the surface and the center of the cross section of the bar. 2. A 8660 steel bar was quenched using mildly agitated molten salt. If it is required that the center of the bar should have a Rockwell hardness of at least 45, what is the maximum value for the diameter of the bar?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
question
Engineering, 04.07.2019 18:10
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
question
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
You know the right answer?
Please solve the following problems using the hardness data from the Jominy end-quench test for 8660...
Questions
question
Mathematics, 29.08.2020 02:01