subject
Engineering, 04.05.2020 22:36 yobanajk

The grade is a measure of quality and it captures concentration levels (i. e., how pure a certain fraction is). If grade captures quality, then Recovery is a measure of quantity: it describes how much of certain material in the input stream is made available for reprocessing. A recovery of R% means that (100 - R)% of the material going into the process is lost, ending up either in mine tailings or as a contaminant in one or more fractions. By weight, copper wire contains about 70% copper and 30% PVC. Suppose we process 1 ton of wire per hour into a copper fraction of 0.74 ton/hour, of which 0.69 is copper and 0.05 is PVC. What is the weight and composition of the tailing?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
You know the right answer?
The grade is a measure of quality and it captures concentration levels (i. e., how pure a certain fr...
Questions
question
Chemistry, 15.06.2021 18:30
question
Mathematics, 15.06.2021 18:30
question
Mathematics, 15.06.2021 18:30
question
Biology, 15.06.2021 18:30
question
History, 15.06.2021 18:30