subject
Engineering, 05.05.2020 04:26 bryan519688

The undisturbed soil at given borrow pit is found to have the following property:
w = 15%; y = 19.1 kN/m^3; Gs = 270
The soil from this borrow pit is to be used to construct a rolled fill having a finished volume of 38, 500 m^3. The soil is excavated by means of a shovel and dumped onto trucks saving a capacity of 4 00 m^3 each. When loaded to capacity, these trucks are found to contain, on the average, a net weight of toil and water equal to 72.7 kN
In the construction process. the trucks dump their load on the fill and the materials spread and broken up, after which a sprinkler adds water until the moisture content is equal to 18%. The soil and water are thoroughly mixed by a disc (or similar equipment) and then compacted until the dry unit weight is equal to 17.3 kN/m^3.
1. Assuming that each load is a full capacity load, how many truckloads are required to construct the fill?
2. How many liters of water will have to be added per truck load, assuming that the moisture tots by evaporation during excavation, haulage, and handling it negligible?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
question
Engineering, 06.07.2019 02:30
Air (c-1.006 kj/kg.k, r-0.287 kj/kg.k) enters a nozzle steadily at 280 kpa and 77°c with a velocity of 50 m/s and exits at 85 kpa and 320 m/s. the heat losses from the nozzle to the surrounding medium at 20°c are estimated to be 3.2 kj/kg. determine (a) the exit temperature and (b) the total entropy change for this process. solve this problem using constant specific heats.
Answers: 1
question
Engineering, 06.07.2019 05:10
The crank case of an automobile is 80 cm long 30 cm wide and 10 cm deep. find out the rate of heat flow from the crank case to the atmosphere when the automobile is moving at 90 km/hr. assume that the vibration of the engine and the chassis iaduce the transition from laminar to turbulent boundary layer may be considered over the entire surface. also find out the drag force on the total surface of the crank case. take the same average convective heat transfer coefficient and average shear stress for front and rare surfaces as for the bottom rnd sides crank case surface temperature is 75°c and atmospheric air temperature is 5 c
Answers: 2
question
Engineering, 06.07.2019 05:20
Calculate the angle of incidence of beam radiation on a surface located at glasgow (56°n, 4°w) at 10 a.m. on 1 february, if the surface is oriented 20° east of south and tilted at 40° to the horizontal
Answers: 1
You know the right answer?
The undisturbed soil at given borrow pit is found to have the following property:
w = 15%; y...
Questions