Assume the incorrect inductor is placed in your circuit by mistake. (i. e. use value of other inductor in parts kit). 1. Calculate VL with ONLY this change in L (i. e. use the frequency of pre-lab calculation results). Show Calculations: VL calculated = ∠ (magnitude and phase) 2. Change the inductors on the circuit protoboard Measure the modified inductor Voltage VL (magnitude and phase) and compare to simulation results. VL measured = ∠ (magnitude and phase) Demonstrate your measurement to lab instructor initials

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.