Engineering, 05.05.2020 06:59 floihqrrigweo

A closed-end cylinder is made of 7079-T651 aluminum alloy. The cylinder has an inside diameter D=1000 mm, has a wall thickness h=20 mm, and is subjected to an internal pressure p=6.0 MPa. Determine the length of crack (2a) required to cause fracture at this pressure if plane strain conditions are assumed to be satisfied. The inside of the cylinder is covered with a thin layer of rubber to prevent leakage.

Take KIC=26 MPa m . From Strength of Materials: a closed cylindrical pressure vessel ÏÎ¸Î¸ = pr t , Ï zz = pr 2t . You can use the stress intensity factor solution for a flat plate with an internal crack for K1 , since the effect of curvature is negligible. If the crack with length 2a=19.1 mm is circumferential instead of longitudinal for the cylinder, determine the internal pressure that will cause fracture.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

A closed-end cylinder is made of 7079-T651 aluminum alloy. The cylinder has an inside diameter D=100...

Questions