Engineering, 05.05.2020 09:38 Countryqueen525

A steel wire sample originally 5.00mm in diameter is drawn through a series of dies at room temperature to a diameter of 3.50mm. Calculate the percentage of cold work associated with this amount of wire drawing.
Your goal is to produce 1.10mm diameter wire from 5.00-mm diameter stock for a wire rope application. If you tried to draw the 3.50mm diameter wire from above any smaller at room temperature it would fracture. So, mathematically show the processing steps you would use to make your 1.10mm diameter steel wire from the 5.00-mm diameter stock. The final diameter needs to be 1.10mm diameter. Key calculations are an important part of your answer.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

You know the right answer?

A steel wire sample originally 5.00mm in diameter is drawn through a series of dies at room temperat...

Questions