subject
Engineering, 05.05.2020 16:32 wbrandi118

A common process for increasing the moisture content of air is to bubble it through a column of water. The air bubbles are assumed to be spheres having a radius of 1.0mm, and are in thermal equilibrum with the surrounding water at 298K. The vapor pressure of water is 0.03 atm at 298K, and the total pressure of the gas inside the air bubble is 1.0 atm.

a) Draw a picture of the physical system and list at least five reasonable assumptions for the mass transfer aspects of the water evaporation process. State what coordinate system should be used.

b)What are the simplified differential forms of Fick's flux equation for water vapor (species A) and the general differential equation for mass transfer in terms of concentration cA ?

c) Propose reasonable boundary and initial conditions

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:20
Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.
Answers: 1
question
Engineering, 04.07.2019 19:10
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
question
Engineering, 04.07.2019 19:10
Arigid tank contains 10 kg of air at 137 kpa (abs) and 21°c. more air is added to the tank until the pressure and temperature rise to 242 kpa (abs) and 32°c, respectively. determine the amount of air added to the tank. [r-0.287 kj/kg k]
Answers: 3
You know the right answer?
A common process for increasing the moisture content of air is to bubble it through a column of wate...
Questions