subject
Engineering, 05.05.2020 16:20 lilloser

5) Initially, the pressure and temperature of steam inside a solid capsule is at 100-pound force per square inch absolute (psia), and 600 degrees Fahrenheit (°F), respectively. Because heat is gradually removed from this container, the pressure inside the capsule drops by the amount of 10-pound force per square inch absolute (psia). Answer the following questions, A. (10 points) The change of entropy per unit mass between the initial and final states B. (5 points) The amount of heat transfer per unit mass for the process C. (5 points) Sketch the T-s diagram for the process, showing the associated values of the thermodynamic properties for states and 2 on your sketch.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
You know the right answer?
5) Initially, the pressure and temperature of steam inside a solid capsule is at 100-pound force per...
Questions
question
Mathematics, 17.11.2020 22:30
question
English, 17.11.2020 22:30