Engineering, 06.05.2020 07:30 cbbentonam72
Calculate pressure in steps of 1 cm in a die of square cross-section for double-action compaction of powders under an applied pressure of 50 MPa. Assume cross-section to be 10 mm x 10 mm and the total length of the compact to be 5 cm. The radial-to-axial pressure ratio is 0.4, and the coefficient of friction is 0.2.
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
Engineering, 04.07.2019 18:20
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
You know the right answer?
Calculate pressure in steps of 1 cm in a die of square cross-section for double-action compaction of...
Questions
Chemistry, 20.10.2019 22:00
Health, 20.10.2019 22:00
SAT, 20.10.2019 22:00
Social Studies, 20.10.2019 22:00
English, 20.10.2019 22:00
Biology, 20.10.2019 22:00
History, 20.10.2019 22:00
Chemistry, 20.10.2019 22:00
Mathematics, 20.10.2019 22:00
English, 20.10.2019 22:00
