Engineering, 25.04.2020 01:55 BreBreDoeCCx

Consider a unity feedback control system with the transfer function:
G(s) = K / [s(s+2)]
in the forward path.
(a) Design a proportional controller that yields a stable system with percent overshoot less than 5% for the step input.
(b) Find settling time and peak time of the closed-loop system designed in part (a).
(c) Design a PD compensator that reduces the settling time computed in (b) by a factor of 4 while keeping the percent overshoot less than 5%.
(d) Add a PI compensator that achieves zero steady-state error for a ramp input and does not change the transient response designed in (c) significantly.
(e) Merge the compensators designed in parts (c) and (d) to find the proportional, derivative, and integral gains of an equivalent PID compensator.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

You know the right answer?

Consider a unity feedback control system with the transfer function:
G(s) = K / [s(s+2)]

Questions