A solid square rod is cantilevered at one end. The rod is 0.5 m long and supports a completely reversing transverse load at the other end of ±1.6 kN. The material is AISI 1080 hot-rolled steel. If the rod must support this load for 4.5 × 105 cycles with a design factor of 1.5, what dimension should the square cross section have? Neglect any stress concentrations at the support end.

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

What precautions should you take to prevent injuries when dealing with heavy loads?

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.