Engineering, 24.04.2020 22:21 brooke1897

You are sampling a signal which consists of a mixture of 160, 164 and 168 Hz sinusoids and which you want to resolve in your FFT. If you are storing 4096 samples, what is the range of sampling frequencies you can use such that you don’t violate Nyquist theorem and still meet or exceed the needed resolution when you perform the FFT operation on the full set of collected data.

a. any frequency greater than or equal to 336 Hz
b. less than or equal to 16384 Hz but greater than 336 Hz
c. less than or equal to 4096 but greater than 336 Hz
d. less than or equal to 8192 Hz but greater than 336

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

Answer

You know the right answer?

You are sampling a signal which consists of a mixture of 160, 164 and 168 Hz sinusoids and which you...

Questions