subject
Engineering, 24.04.2020 03:02 bestdiva2

One-dimensional, steady-state conduction with uniform internal energy generation occurs in a plane wall with a thickness of 50 mm and a constant thermal conductivity of 5 W/m*K. For these condtions, the temperature distribution has the form T(x)=a+bx+cx^2. The surface at x=0 has a temperature of T(0)=To=120 deg. (C) and h=500 W/m^2*K. The surface at x=L is well insulated.(a) Applying an overall energy balance to the wall, calculate the volumetric energy generation rate q.(b) Determine the coefficients a, b,c by applying the boundary conditions to the prescribed temperature distribution. Use the results to calculate and plot the temp. distribution.(c) Consider conditions for whic hthe convection coefficient is halved, but q remains unchanged. Determin the new values for a, b,c and plot the temperature dist. (Hint: T(0) is no longer 120)(d) Under conditions for which q is doubled and the convection coeff. remains unchanged (h=500 W/m^2*K) determine new a, b,c and plot temp distribution. Compare (a),(b),and (c) and discuss the effects of h and q on the distributions.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
You know the right answer?
One-dimensional, steady-state conduction with uniform internal energy generation occurs in a plane w...
Questions
question
Geography, 04.02.2021 18:00
question
English, 04.02.2021 18:00
question
Chemistry, 04.02.2021 18:00
question
English, 04.02.2021 18:00
question
Mathematics, 04.02.2021 18:00