Engineering, 24.04.2020 00:58 mocheal8216

A paper plant is proposed for a location 1 km upwind from a town. It will emit 40 g/s of hydrogen sulfide, which has an odor threshold of about 0.1 mg/m3. Assume that winds at 10 m above ground are 2.5 m/s, and at the effective stack height they typically vary from 4 – 10 m/s blowing toward the town. If it is summer day with a few broken clouds,

a) What stack height should be used to assure concentrations are no more than 0.1 times the odor threshold at the near edge of town (1 km away)? To be conservative, the stack will be designed assuming no plume rise.

b) Will any buildings (e. g., the country cabin or the doghouse on the far edge of town – hey, dogs matter too!) experience higher concentrations than a residence at the 1 km boundary? Briefly explain your answer.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

You know the right answer?

A paper plant is proposed for a location 1 km upwind from a town. It will emit 40 g/s of hydrogen su...

Questions