Engineering, 22.04.2020 16:27 sibr4566

G 4. Consider a stepper motor with two phases. Phase 1 is wound with two identical coils. Phase 2 is also wound with two identical coils. Therefore, there are eight wires that come out from the stator winding, four for each phase. (a) Connect the phase terminal wires in such a way that the motor can be used as a unipolar wound motor and draw a schematics for the amplifier circuit of the motor windings. (b) Connect the phase terminal wires in such a way that the motor can be used as a bipolar wound motor with series connected windings (two identical windings for each phase are connected in series). Draw the amplifier circuit and its connections to motor windings. (c) Connect the phase terminal wires in such a way that the motor can be used as a bipolar wound motor with parallel connected windings (two identical windings for each phase are connected in parallel). Draw the amplifier circuit and its connections to motor windings

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?

Answers: 3

Answer

You know the right answer?

G 4. Consider a stepper motor with two phases. Phase 1 is wound with two identical coils. Phase 2 is...

Questions