Engineering, 21.04.2020 16:17 igtguith

A company produces electric insulators. The strength of the insulators is important since a broken insulator may cause a short circuit. Unfortunately, the strength varies significantly due to the material. Because of the expense, only a limited number of insulators could be tested. The engineers sampled 25 insulators (From a production run of 200), and conducted a destructive test to determine the force that was required to break the insulators. The mean value of this force was 1723 lbf with a sample standard deviation of 90 lbf. You may approximate the population standard deviation with the sample standard deviation for the following questions.

a. Determine if the population is large enough or if a finite population correction (FPC) factor is needed. If so, what is the FPC factor?

b. For 95% confidence, determine the margin of error (+ lbf)

c. For these conditions, estimate the range of the probable population mean. Provide lower and upper values. For 95% confidence, determine the margin of error ( Assume the same mean and sample standard deviation. What is one advantage and one disadvantage of using 50 insulators instead of 25 insulators?

d. lbf) if 50 insulators were tested.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

You know the right answer?

A company produces electric insulators. The strength of the insulators is important since a broken i...

Questions