Engineering, 21.04.2020 15:55 winnie45

You are an engineer at company XYZ, and you are dealing with the need to determine the maximum load you can apply to a set of bolted/clamped plates, such that you get infinite life. a) (1.5 pt) If you have an coarse thread M12 x 1.75 bolt of SAE Class 5.8, what would you recommend as the initial tightening force in the bolt? Is this initial force in the bolt the same as the clamped members?Hint: Use Fi = 0.9AtSp. b) (2 pt) If the clamped members have an effective stiffness twice that of the bolt and an external separating load varies between 0 and 5 kN, what are the alternating and mean forces on the bolt? What are the mean and alternating stresses in the bulk of the bolt? c) (1.5 pt) If the fatigue stress concentration factor is Kf=2.2 for the threads and we account for a yield strength of 400 MPa, what are the ef

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 06.07.2019 02:30

On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)

Answers: 2

Answer

Engineering, 06.07.2019 04:20

Consider the transfer function for a first-order system g(s)=12(s+7)/(s^2+2s+9) for this system determine: a) poles and zeros of the function, b) the natural frequency and damping ratio, c) the peak value achieved in response to a unit step input, d) the peak time for a unit step input, e) the steady-state system response to a unit step input

Answers: 2

Answer

You know the right answer?

You are an engineer at company XYZ, and you are dealing with the need to determine the maximum load...

Questions