Engineering, 18.04.2020 04:11 Savagepanda911

The label on a bleach bottle states that it contains 5.25% (by mass) sodium hypochlorite (NaOCl). Assume that the bleach is manufactured by adding this chemical to otherwise pure water. Take the density of bleach to be the same as that of pure water, 1.0 g cm^-3. Assume that the NaOCl dissociates completely and the pKa for hypochlorous acid is 7.6.

a. What is the pH of bleach?
b. Bleach can be used as an emergency disinfectant for example, for water after an earthquake. Assume that the target dose of free residual chlorine (HOCI + OCI-) to be added is 50 g m^-3. How much bleach (in cm^3) would you add to 1 L of water to disinfect it?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

Answer

You know the right answer?

The label on a bleach bottle states that it contains 5.25% (by mass) sodium hypochlorite (NaOCl). As...

Questions