subject
Engineering, 17.04.2020 04:33 valvaldeziv6373

2.13. Nitrogen, traveling at 12 m/s with a pressure of 14 bar abs. at a temperature of 800 K, enters a device with an area of 0.05 m2 . No work or heat transfer takes place. The temperature at the exit, where the area is 0.15 m2 , has dropped to 590 K. What are (a) the velocity and (b) pressure at the outlet section?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
question
Engineering, 06.07.2019 03:20
What is the strain energy stored in a solid uniformly circular shaft of length 3.0 m and diameter 120 mm when subject to pure torsion if the maximum shear stress is 40 mpa? g-80gpa
Answers: 1
You know the right answer?
2.13. Nitrogen, traveling at 12 m/s with a pressure of 14 bar abs. at a temperature of 800 K, enters...
Questions
question
History, 25.10.2021 14:00
question
Social Studies, 25.10.2021 14:00
question
Mathematics, 25.10.2021 14:00
question
Mathematics, 25.10.2021 14:00
question
Mathematics, 25.10.2021 14:00