Engineering, 15.04.2020 17:24 vanvalenpeyt

Show how to connect the two circuit building blocks from the previous problem to create a circuit that transforms a priority-encoded input into a one-hot encoded output, where the highest-priority hot signal from the input is the hot signal in the output. For example, if the input to the circuit is WoWiWzW3W4W5W5W7 = 01101010, then the circuit should output yoy1yzysyysyy, = 00000010, because ws is the highest-numbered hot signal in the input. Additionally, your circuit should support the case where no signals are hot, i. e., if WoWiWzW3W4W5W5W7 = 00000000, then the circuit should output yoyzyzy3y4ysycyz = 00000000.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

What is creep? what is stress relaxation?

Answers: 1

Answer

Engineering, 06.07.2019 03:10

Consider a 1.2 meter high and 2 meter wide glass window whose thickness is 6 mm and thermal conductivity is 0.78 w/m °c. the room temperature is maintained at 24 °c, while the outdoor temperature is -5 °c. the convective heat transfer coefficients on the inner and outer surfaces of the window are 10 w/m2 °c and 25 w/m2 °c respectively. (a) draw the thermal resistance network, etermine the steady rate of heat transfer t e glass window (c) determine the temperature of the inner surface of the window

Answers: 3

Answer

Engineering, 06.07.2019 03:10

An electrical kettle is made out of stainless steel,weighs two pounds (when empty) with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling.

Answers: 1

Answer

Engineering, 06.07.2019 03:20

Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing

Answers: 3

Answer

You know the right answer?

Show how to connect the two circuit building blocks from the previous problem to create a circuit th...

Questions