subject
Engineering, 15.04.2020 05:14 simmonsl7790

An NDE test method can detect through cracks of lengths greater than 2-mm. A given component consists of a strip of width 30 mm and thickness 4-mm and is subjected to an alternating load in service of 20±10kN. The material has a fracture toughness ICK= 30 MPam. Laboratory experiments suggest that under these conditions fatigue cracks grow exponentially according to the equation a = a0 exp(λt), where t is the length of time in service in seconds, a0 is the original crack half-length at t = 0 and λ = 10−8 s−1. Determine the minimum inspection frequency of NDE testing (that is, after how many seconds of service) if brittle failure during the intervening period is to be avoided

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
An NDE test method can detect through cracks of lengths greater than 2-mm. A given component consist...
Questions
question
Mathematics, 10.09.2021 01:00
question
Social Studies, 10.09.2021 01:00