Engineering, 14.04.2020 17:36 mohayon2020
The length of a proposed submarine is 100 m and the planned speed is 20 km/hr. In order to estimate the power requirements for the propulsion system, the vehicle resistance must be evaluated. It was proposed to build a wind tunnel model of the submarine and test it in air. If using the similitude assumption (e. g., keeping Re the same), what is the required length of the wind tunnel model if test speed is 80 m/sec
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Engineering, 06.07.2019 02:30
A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.
Answers: 1
You know the right answer?
The length of a proposed submarine is 100 m and the planned speed is 20 km/hr. In order to estimate...
Questions
Mathematics, 29.01.2020 21:58
Mathematics, 29.01.2020 21:58
Mathematics, 29.01.2020 21:58
Social Studies, 29.01.2020 21:58
