Engineering, 08.04.2020 03:14 MK100

A storm hits a small (15 km2) catchment and runoff is generated. You have been given a time series (see below; the picture is also stored in the files folder) of precipitation input and stream flow. You may assume that ET during this time is negligible and that there is no change in canopy storage. About 2.2 cm of input water is stored in depressions and as soil moisture. Required: (a) Plot a simultaneous hyeto-hydrograph of the event, to scale, on engineering paper. Include dual vertical axes, with units. Label and scale all axes. (b) Use a graphical method to separate the hydrograph. Label the event flow and baseflow. Show your work, indicating the method you chose and steps taken to separate the hydrograph. (c) Compute p/P (d) Compute Q

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

A storm hits a small (15 km2) catchment and runoff is generated. You have been given a time series (...

Questions