Engineering, 08.04.2020 00:56 Mathinator
The top surface of a rectangular workpart is machined using a peripheral milling operation. The workpart is 750 mm long by 50 mm wide by 100 mm thick. The milling cutter, which is 70 mm in diameter and has five teeth, overhangs the width of the part equally on both sides. Cutting speed = 80 m/min, chip load = 0.35 mm/tooth, and depth of cut = 7.5 mm.
(a) Determine the time required to make one pass across the surface, given that the setup and machine settings provide an approach distance of 5 mm before actual cutting begins and an overtravel distance of 25 mm after actual cutting has finished.
(b) What is the maximum material removal rate during the cut?
Answers: 1
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Engineering, 04.07.2019 18:20
Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k
Answers: 2
Engineering, 04.07.2019 19:20
At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2
Answers: 2
The top surface of a rectangular workpart is machined using a peripheral milling operation. The work...
Biology, 23.04.2020 22:17
History, 23.04.2020 22:17
Physics, 23.04.2020 22:17
Mathematics, 23.04.2020 22:17
Biology, 23.04.2020 22:17
Geography, 23.04.2020 22:17
Chemistry, 23.04.2020 22:17
Biology, 23.04.2020 22:18
Mathematics, 23.04.2020 22:18
Mathematics, 23.04.2020 22:18