Engineering, 08.04.2020 00:01 jmalfa

Develop a list of network security controls for the Ken 7 Windows environment.

Requirements

Ken 7 Windows Limited has added several new servers and workstations to the Ken 7 domain to support the new enterprise resource planning (ERP) software. They have also added many internal users and plan to allow access from remote users to their internal network resources. Ken 7 Windows Limited needs additional network controls to protect their growing network.

Consider the Windows servers and workstations in the domains of a typical IT infrastructure. Based on your understanding of network security controls, recommend possible new controls that will enhance the network’s security. Focus on ensuring that controls satisfy the defense in depth approach to security.

Summarize your network security controls. You must provide rationale for your choices by explaining how each control makes the environment more secure.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

Answer

You know the right answer?

Develop a list of network security controls for the Ken 7 Windows environment.

Requireme...

Questions